How do you connect LED lights to a motorcycle?
Attaching the LED Strips to Your Motorcycle. Attach velcro to your LED strips. Once you know exactly where all of your strips need to go, you can go about attaching them to the motorcycle. Many LED kits will come with tape strips already attached, but after sticking them, you’re pretty much stuck with the design.
Do I need a special transformer for LED lights?
All mains powered LED bulbs require a transformer. Depending on the bulb type, the transformer/driver may be built in to the bulb casing or may be located externally. The purpose of the transformer is to reduce mains voltage (240V) to the desired level relative to the bulb being powered (e.g. 12V or 24V).
Can you wire LED lights to a plug?
LED lights are a great way to add functional lighting or a bit of flair to a space. They’re also super easy to wire. You can connect an LED strip to an adapter and then plug it in to power it. You can also use a wire splicer to tap your LED lights into an existing and functioning wire to provide power for the lights.
Is Underglow on a motorcycle illegal?
Motorcycle Underglow Adding Underglow lighting to your motorcycle is legal in California, but it does come with some regulations. You can use any colors for the underglow except for red because it cannot be displayed in the front of the bike.
Is it illegal to put LEDs on a motorcycle?
As a general principle, LEDs are legal so long as they remain concealed and unlit on roads and do not flash or include the colors red or blue for obvious reasons. (3) an alternately flashing light.
How do you mount LED lights on a motorcycle?
Your specific LED kit may come with instructions for where to mount your lights, but if not, use painter’s tape to temporarily attach them to the motorcycle. Try a couple of designs and make sure that you have enough strips to complete the design you want.
How to test Motorcycle LED light strips?
In most models of motorcycle, you will find the battery located beneath the seat. By disconnecting the battery, you can test your LED light strips without worry of harming the other motorcycle components that it powers. Test locations for your LED strips.
How do you install an LED light switch?
Pick a placement for your switch. Your LED kit will come with a switch, which should have three leads on the back—positive, negative, and ground. Pick a comfortable location where you will later mount the switch. Attach velcro to your LED strips.
How can I improve the reception on my motorcycle lights?
Some kits may also have a key fob remote control for the lights, in which case you will also need to run the antenna wire down the frame of the motorcycle to improve reception. Thanks! Ensure that you disconnect the motorcycle battery before you get started.