How do I reset my Maytag dishwasher control panel?
Reset the control panel to get the dishwasher to function normally.
- Open and close the door of your Maytag dishwasher.
- Locate the “Rinse” button on the dishwasher control panel.
- Press and release the adjacent “Drain/Off” button on the control panel two times; this will deactivate the dishwasher’s demo mode.
Why is my Maytag dishwasher start light blinking?
The Start/Resume light flashing, (Select models), indicates the cycle or start-up was interrupted. This can happen if the door is opened during the cycle or power has been interrupted. Push the door firmly closed within 3 seconds of pressing Start/Resume.
How do I turn off the control lock on my Maytag dishwasher?
To turn off Control Lock, press and hold the Options key that says “Control Lock Hold 3 Sec” under it for 3 seconds. If the dishwasher has a dedicated Control Lock button in the Options selections, press and hold CONTROL LOCK for 3 seconds (press the words “Control Lock).
Can you reset a dishwasher control board?
How Do I Reset My Dishwasher Control Panel? Simply unplug your dishwasher. Wait for one minute, then plug it back in again, to reset the dishwasher control panel.
How do you reset a Maytag?
The easiest way to reset a Maytag washer is to disconnect the power to the washing machine for three minutes. Disconnecting the power allows the electrical charge to dissipate from the washing machine, which allows it to reset. If the reset fails, unplug the washer again, this time leaving it unplugged for ten minutes.
Why is my dishwasher stuck on Control Lock?
This is a sign of a child lock is on. You should press and hold the start button for five seconds. Then, release the button, disengaging the child lock. This is one of the most common reasons why this dishwasher will not open, so it should be enough to fix the issue.
How do I know if my control panel is bad on my dishwasher?
Signs of Whirlpool dishwasher control board problems
- Cycles not starting (or very delayed starting) when you press the start button or the dishwasher only accepting to run on some cycles (for example, heavy duty).
- Error codes or flashing lights on your dishwasher.
- The dishwasher failing to run completely.
How do I hard reset my Maytag washer?
Press and hold the Start/Pause button for 3 seconds. All indicator lights should be off at this point. Reset the Washer: To reset (clear) the washer, rotate the Cycle Selector Knob counter-clockwise (left) to clear any sequence.
How do you reset your dishwasher?
Resetting your dishwasher is easy. Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the dishwasher (usually 1 to 5 minutes at most), and then power it up again. That’s it. That’s all it takes to reset.
Why is my Maytag dishwasher not starting?
If your dishwasher is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in. If the dishwasher is hard wired to the power supply, turn the breaker off at the home electrical panel that powers the dishwasher for one minute and then turn the breaker back on.