How do I program Vista 128fbp?

How do I program Vista 128fbp?

To enter program mode, enter installer code + [8] + [0] + [0] + [0] • To set standard defaults, press *97 • To change to next page of program fields, press *94 • To return to previous set of fields, press *99 • To erase account & phone number field entries, press [*] + field number + [*] • To assign zone descriptors.

How do I change the time on Vista 128fbp?

To set the real time clock, enter the installer code (factory default code is 4140) or the master code, followed by the pound (#) key and the numbers 63 (4140#63 without pausing between numbers).

What is the maximum number of addressable devices on a Vista 128 ECP bus?

The Vista 128BPT control panel can support up to 16, 2 wire smoke detectors on zone 1 and supports a zone type for carbon monoxide. The Vista 128BPT can support up to a maximum of 31 alpha keypads and up to 6 graphic keypads.

How do you program a Honeywell alarm system?

Here’s how to do it:

  1. Unplug the transformer from the power source.
  2. Disconnect the battery.
  3. Plug the transformer back in.
  4. Reconnect the battery.
  5. Within 30 seconds of turning the alarm system on, press * and # at the same time.
  6. Enter *20.
  7. Enter a new 4 digit installer code.
  8. Press *99 to exit programming mode.

Can you program Vista 20P with computer?

Compass software is useful for programming Honeywell alarm control panels through a computer. Instead of using a keypad hooked up to your VISTA-20P, you can use the Compass software to configure all programming settings and then download the settings to the alarm control panel.

How do I find my Honeywell keypad address?

You can view your programmed keypad address at anytime by pressing [1] and [3] at the same time for (3) seconds. The alarm keypad will display the currently programmed address, but it will not allow you to change it unless you power the keypad down.

How many keypads can you put on Vista 20P?

8 keypads
How Many Keypads Can Be Added? Honeywell Vista 20P control panel can accommodate up to 8 keypads.

How do I change my Vista 128 code?

Complete the following steps to change the Master Code on a VISTA 128BPT:

  1. Signify a code command. On your keypad (preferably an alphanumeric keypad), enter in the following:
  2. Identify the user number.
  3. Provide the new code.
  4. Do not add new user.
  5. Confirm the new code.