How do I fix error code P2118?

How do I fix error code P2118?

Generally, simple repairs such as these fix the P2118 code:

  1. Wiring harness repaired or replaced.
  2. Throttle actuator control motor replaced.
  3. Pedal position sensor replaced.
  4. Faulty throttle position sensor replaced.
  5. Poor electrical connection resolved.

How do I reset the throttle actuator control module?

Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.

How do you calibrate a throttle actuator?

Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.

Where is throttle actuator control located?

The throttle controller is located on top of the engine between the air intake and the intake manifold.

How do I reset my Toyota throttle body?

First Throttle Sequence

  1. Put the key in the ignition.
  2. Turn the key to the On position, without cranking the engine. Wait a few seconds, then turn it off.
  3. Repeat the second step.
  4. Crank the engine.
  5. Pull the parking brake.
  6. Set the gear lever in Drive.
  7. Wait 5-10 minutes.

How do I manually reset my throttle body?

The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.

What does the p2118 code mean on a car?

Code P2118 is set by the PCM when the Throttle Actuator Control Motor is out of range or not performing properly. The PCM controls the Throttle Actuator Control System by monitoring one or more throttle position sensors.

How much does it cost to diagnose a p2118 scion code?

The cost of diagnosing the P2118 SCION code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. | When is the P2118 SCION code detected?

What color should the battery post be on a p2118 engine?

It should be red to red on battery post marked (+), black cable to the engine any bare metal. P2118 engine code, and the vehicle would not accelerate at all. what should I do?